P060D - Accelerator Pedal Position Sensor Performance
The Powertrain Control Module (PCM) has detected an internal performance issue with the accelerator pedal position (APP) sensor circuit. This code indicates that the signal from the APP sensor is not within the expected range or is inconsistent, often due to a faulty sensor, wiring issues, or a PCM internal fault.
01. Most Common Causes
- Faulty accelerator pedal position sensor
- Wiring or connector issues in the APP sensor circuit
- Internal PCM failure
02. Symptoms You Will Notice
- Check Engine Light illuminated
- Reduced engine power or limp mode
- Poor acceleration or hesitation
- Erratic throttle response
03. Step-by-Step Diagnosis
Step 1: Scan for additional codes and freeze frame data.
Step 2: Visually inspect the APP sensor connector and wiring for damage or corrosion.
Step 3: Test the APP sensor voltage and resistance with a multimeter per manufacturer specs.
Step 4: If sensor and wiring are OK, check for PCM software updates or replace PCM.
04. Commonly Affected Makes
05. Frequently Asked Questions
Is it safe to drive with this code?▼
It is not recommended as it can cause sudden loss of throttle control or reduced power, leading to unsafe driving conditions.
How much does it cost to fix?▼
Diagnosis typically costs $50-$150. Replacing the APP sensor can range from $100-$300, while PCM replacement may exceed $500.